安徽快3开奖结果

全国服务热线:18631165157
网站公告:
诚信换来金招牌 服务赢得天下客...
联系我们
18631165157
地址:
安国市南阳工业区
邮箱:
415130881@qq.com
电话:
18631165157
传真:
0312-3427286
手机:
18631165157
安徽快3开奖结果 News
渣浆泵功率过大电机发热是什么原因
添加时间:2019.12.03

渣浆泵功率过大电机发热是什么原因
故障原因:1)泵的流量过大,超过使用范围2)转速过高3)电压太低4)密封环磨损过大5)输送液体相对密度大6)轴向力平衡装置失效7)泵的转动部件有摩擦8)电机质量不好9)填料压得太紧
排除方法:1)关小出口阀门2)降低转速到额定转速3)检查原因、消除4)检查测量更换密封环5)更换原动机,加大功率6)检查原因、消除7)检查消除8)检验电机质量,修理或更换9)松填料 渣浆泵厂家

What is the cause of the motor heating when the power of slurry pump is too high

Fault cause: 1) the flow of the pump is too large, which exceeds the scope of use; 2) the speed is too high; 3) the voltage is too low; 4) the seal ring is too worn; 5) the relative density of the delivered liquid is too high; 6) the axial force balancing device fails; 7) the rotating parts of the pump have friction; 8) the motor quality is not good; 9) the packing is pressed too tight

Troubleshooting: 1) turn down the outlet valve; 2) reduce the speed to the rated speed; 3) check the cause and eliminate it; 4) check, measure and replace the sealing ring; 5) replace the prime mover and increase the power; 6) check the cause and eliminate it; 7) check and eliminate it; 8) check the quality of the motor and repair or replace it; 9) loose packing slurry pump manufacturer




博盛彩票APP下载 湖北快3开奖结果 爱波彩票APP下载 百易彩票APP下载 湖北快3走势图 博美彩票官网 安徽快3基本走势图50期 湖北快3 安徽快3开奖结果安徽快3基本走势图50期 爱彩彩票APP下载